Cart is empty

ColorCote® MagnaFlow™ 0.55mm

Price on request
Out of stock

Minimum quantity for "ColorCote® MagnaFlow™ 0.55mm" is 1.

Suppliers follow Australian Consumer Law and may offer warranties and refunds. Evitat does not control Supplier policies but values customer experience. Please refer to supplier refund policies. Contact us if you cannot resolve an issue with the Supplier.

This product is on because of

Avoiding risk of heat stress or cold-related illnesses

Low or No VOCs (volatile organic components) or nasty chemicals

Good insulation for well regulated room temperatures

MagnaFlow™, a roofing product is made up of a hot dipped aluminium/zinc alloy mixed with magnesium  coating over a steel substrate. This enables the zinc to seal the cut edges thus preventing premature corrosion. The substrate is coated to at least 240gms/m2 coating weight and manufactured to AS 1397:2011 standard. The product can be used in atmospheric conditions classified as C1-C4 and is designed for the more demanding atmospheric conditions.  The product is pre-treated with a corrosion resistant chromate conversion coating and primed with a flexible corrosion resistant chromated primer with nominal film thickness of 7μ on the top side and 5μ on the reverse. The finish is completed with a flexible exterior acrylic, polyester or modified coating with a nominal thickness of 18μ.

Finish Coat:
Flexible exterior acrylic, polyester or modified polyester coating system

Main features

Product Certifications:
  • GreenRate Level A (Global GreenTag)
Sustainability features:
  • Low VOC
  • No toxicity

15 years

62 years

Global warming potential(A1-A3)

14.6 kgCo2-Eq of embodied carbon per 1m2 of MagnaFlow™ 0.55mm thick manufactured.

Global Warming Potential(A4)

Not declared

Total Global Warming Potential

14.6 kgCo2-Eq

Not applicable

A recycling rate of 89% is assumed

GreenTag GreenRate Level A

  • Mar Resistance: Good
  • Scratch Resistance: Good
  • Impact Resistance: (AS/NZS 2728 Appendix E) – Greater than 10 Joules
  • Pencil Hardness: (AS/NZS 1580.405.1) – F minimum
  • Bend Test: (AS/NZS 2728 Appendix F) – No loss of paint adhesion when bent around a diameter equal to five times the thickness of the sheet.
  • Heat Resistance: Suitable for continuous service up to 100C. Continuous service at higher temperatures may cause some colour change of the paint film.